Planned Maintenance Agreements (Residential Customers Only)
Baumberger Heating & Cooling has been serving Richland and surrounding Counties since 1982. As a result of our longevity, we fully understand the importance of maintaining your heating & cooling equipment and offer Planned Maintenance Agreements that suit your specific need.
Planned Maintenance Agreement Facts:
- Your heating & cooling system uses more energy than any other appliance in your home, accounting for up to 70% of your utility bill. It’s important to keep your unit tuned-up and operating efficiently with a maintenance plan.
- Regularly performed maintenance can extend the life of your system by 48%.
- Properly maintained equipment operates at peak efficiency, minimizing energy consumption and utility costs.
- With annual checks, minor problems are uncovered and adequate adjustments reduce the potential for further breakdowns.
Major Benefits of a Planned Maintenance Agreement:
- Peace of Mind
- A “Preferred Customer” status
- Annual Safety Inspection
- Priority Service
- Convenience
- Money Savings
- 30 Day Labor & Part Warranty
- 10% savings on any repair charge
- No after hours charges
- Worry Free Scheduling! We call you when it’s time for service!
- Filter Changes every 6 months
- 24/7 Emergency Service
Our Planned Maintenance Agreement Inspections include:
Heating Season Inspection:
- Inspect and verify Thermostat operation
- Check / change standard filter or air cleaner (replacement filters & humidifier pads sold separately)
- Measure amp draw on all motors
- Inspect condensate pump if needed
- Inspect and clean all drain lines
- Visually inspect all safety controls
- Start & inspect system operation
- Inspect blower assembly, lubricate if necessary
- Inspect and tighten, both high voltage and low voltage circuits
- Measure temperature rise
- Inspect evaporator coil when applicable
- Inspect expansion valve or metering device
- Inspect reversing valve where applicable
- Check refrigerant superheat when applicable
- Inspect condenser fan motor operation
- Test for Carbon Monoxide Leaks
- Inspect & rinse condenser coil if applicable
- Check contactor for pitting or worn spots when applicable
- Inspect and clean vent and intake piping
- Inspect flue draft or draft inducer assembly
- Inspect pressure switches and vacuum hoses
- Inspect manifold assembly or heating elements
- Inspect and clean ignition assembly and flame sensor
- Visually inspect heat exchanger for stress or wear
- Inspect humidifier and verify proper operation In addition for boilers, we inspect:
- All controls
- All safeties
- Low water cut-offs
- Lubricate Pump
- Inspect the site glass
Cooling Season Inspection:
- Inspect and verify thermostat operation
- Check / change standard filter or air cleaner (replacement filters & humidifier pads sold separately)
- Measure amp draw on all motors
- Inspect condensate pump, if applicable
- Inspect and clean all drain lines
- Visually inspect all safety controls
- Start & inspect system operation
- Inspect blower assembly, lubricate if necessary
- Inspect and tighten, both high voltage and low voltage circuits.
- Inspect capacitor
- Inspect contactor for pits or excessive wear
- Inspect evaporator coil
- Inspect expansion device
- Inspect reversing valve, if applicable
- Inspect condenser fan operation
- Inspect condenser for level
- Measure temperature drop
- Check refrigerant sub-cooling
- Inspect disconnect, electrical wiring, and fuses
- Inspect and rinse condenser coil
- Check service valve caps and connections
- Seasonal shut-down of humidifier when applicable
Baumberger Heating & Cooling offers the following pricing on select systems. These are our most common configurations. If you don’t see your system listed, please contact one of our team members for pricing.
Planned Maintenance Agreement Pricing:
Click Here for our complete Planned Maintenance Agreement.